Table of Contents
Advertisement
15 WIRING HARNESS, BATTERY
123
Mount engine electronics control unit O-
O
[r
R01415-10
Finishing work
- Mount the seat. (KS p. 83)
Checking the open-circuit current
15.7
Preparatory work
-
Switch off the ignition by turning the ignition key to the OFF 53 position.
-
Remove the seat. (iS p. 82)
Main work
-
Pull engine electronics control unit O off of the holder and set it to one side.
O
R01415-10
Remove screws
0
Pull retaining bracket
©
of the battery forward and remove it.
i
m
L. '
[fe
0
I
R01416-10
Disconnect the negative cable of the battery.
Measure the current between battery ground (-) and the negative cable.
i
A
+
Info
The value of the open-circuit current only applies to vehicles in their origi
nal state without additional power consumers.
I
a
n
I
Maximum open-circuit current
<1.0 mA
» If the measured value is greater than the specified value:
- Disconnect the voltage regulator from the wiring harness and perform the
measurement again.
Connect the battery. (H p. 120)
Position
retaining
bracket
0
Mount and tighten screws
0
Guideline
D00867-10
—
rfe
10 Nm (7.4 Ibf ft)
Remaining screws, chassis
M6
©
I'!L
a
R01416-10
Advertisement
Table of Contents
