Husqvarna 701 Enduro 2017 Repair Manual page 38

6 FORK, TRIPLE CLAMP
36
Tighten screw ©.
Guideline
Screw, top steering head M20x1.5 12 Nm (8.9 Ibf ft)
f
D02815-10
Mount and tighten screw ©.
Guideline
Screw, steering stem
M8 20 Nm (14.8 Ibf ft)
O
D00936-10
t
Using a plastic hammer, tap lightly on the upper triple clamp to avoid stresses.
Tighten screws ©.
Guideline
©
Screw, top triple clamp M8 17 Nm (12.5 Ibf ft)
;
r
„
rs
i
D02814-10
Mount and tighten screws
Guideline
10 Nm (7.4 Ibf ft)
Remaining screws, chassis M6
3§n
m
iv-
D00923-11
Position the brake line, wiring harness, and clamp. Mount and tighten screws ©.
Position the holder, and mount and tighten screws ©.
Guideline
n
Loctite® 243™ Wheel speed sensor
screws on holder
M5 3 Nm
(2.2 Ibf ft)
<D
B
€)
D01007-10
®
v
# {
Position the brake caliper.
Mount and tighten screws
Guideline
/
Loctite® 243™ Screw, front brake caliper M8 25 Nm
(18.4 Ibf ft) j
Route the cable for the wheel speed sensor without tension.
Position the wheel speed sensor. Mount and tighten screw ©.
Guideline
■
D01006-10
Screw, wheel speed sensor M6 6 Nm (4.4 Ibf ft)