Table of Contents
Advertisement
22 LUBRICATION SYSTEM
240
Coolant temperature: > 70 °C
(> 158 °F)
Engine speed: 5,000 rpm
> 1.5 bar (> 22 psi)
» If the measured value is less than the specification:
- Change the oil filter. Check the oil pumps for wear. Check that all oil holes
are clear.
Switch off the engine.
Warning
Danger of burns Some vehicle components get very hot when the
machine is driven.
- Wear appropriate protective clothing and safety gloves. In case of
burns, rinse immediately with lukewarm water.
A
Remove the special tools.
Mount and tighten screw O-
Guideline
Screw, unlocking of timing chain ten
sioner
M10x1
10 Nm (7.4 Ibf ft)
Finishing work
- Check the engine oil level, (il p. 238)
Changing the engine oil and oil filter, cleaning the oil screens
22.4
Warning
Danger of scalding Engine and gear oil get very hot when the motorcycle is ridden.
-
Wear suitable protective clothing and safety gloves.
-
In the event of scalding, rinse the area affected immediately with lukewarm water.
A
Warning
Environmental hazard Hazardous substances cause environmental damage.
- Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the applicable
regulations.
Info
Drain the engine oil while the engine is at operating temperature.
I
Preparatory work
-
Remove the engine guard. (fiJ p. 43)
Main work
-
Place a suitable container under the engine.
-
Remove oil filler plug O with the O-ring from the clutch cover.
/
/
/
o
I
\
v
H01066-10
Remove oil drain plug
©
with the magnet and seal ring.
Completely drain the engine oil.
J
r
r
A
f
o
©
F00579-10
Advertisement
Table of Contents
