Checking The Starter Drive - Husqvarna 701 Enduro 2017 Repair Manual

18 ENGINE
200
Position lock ring
©
on special tool and push down with sleeve ©.
S The lock ring engages in the groove of the transmission shaft.
Mount stop disk ©.
Mount needle bearing © and fourth-gear idler gear
®
with the collar facing upward.
Mount needle bearing © and third-gear idler gear © with the collar facing downward.
Mount stop disk
©
Position special tool on the transmission shaft.
Mounting tool for lock ring (76629032000) (KS p. 328)
Position lock ring
©
on special tool and push down with sleeve ©.
S The lock ring engages in the groove of the transmission shaft.
Mount fifth-gear sliding gear
©
with the shift groove facing downward and stop disk
©
Mount needle bearing
©
, first-gear idler gear
©
with the recess facing downward and stop disk ©.
Finally, check all gear wheels for smooth operation.
18,4,39 Checking the starter drive
ft
©
©
o
o
°0
©
©
©
t'.A
311875-10
Check the gear mesh and bearing of starter idler gear O for damage and wear.
» If there is damage or wear:
- Change the starter idler gear and/or needle bushing.
Check the gear teeth and bearing of torque limiter
©
for damage and wear.
» If there is damage or wear:
- Change the torque limiter and/or needle bearing.
Check freewheel gear
©
and bearing when removed for damage and wear.
» If there is damage or wear:
- Change the freewheel gear or bearing.
Check freewheel © when removed for damage and wear.
» If there is damage or wear:
- Change the freewheel.