Husqvarna 701 Enduro 2017 Repair Manual page 133

16 BRAKE SYSTEM
131
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
Cover painted parts.
Remove screws O-
Take off cover with the membrane.
Draw the old brake fluid out of the brake fluid reservoir using a syringe and fill
with fresh brake fluid.
k\
©
o
o
s
Bleed syringe (50329050000) (K8 p. 320)
Brake fluid DOT 4 (SM p. 316)
D00856-10
Mount bleeder cover
e
I
Bleeder cover (00029013015) (SM p. 319)
m
Connect the bleeding device.
«r
Bleeding device (00029013100) (S3 p. 319)
i
D00943-10
Open shut-off valve ©.
O
Info
Follow the instructions in the Owner's Manual of the bleeding device.
I
O
V
i
jm
i kk
©
Ensure that the filling pressure is set on pressure gauge
o
. Correct the filling
pressure on pressure regulator © if necessary.
Guideline
2... 2.5 bar (29... 36 psi) Filling pressure
201494-10
Pull off protection cap
©
of the brake caliper bleeder screw. Connect the
bleeder bottle hose.
/
w
©
Bleeding device (00029013100) (P p. 319)
Open bleeder screw by approx, one half turn.
Info
Drain until fresh brake fluid emerges in the bleeder bottle hose without
bubbles.
I
%
r
D00945-10
Tighten the bleeder screw.
Close shut-off valve ©.
Open the bleeder screw again until brake fluid stops emerging.
Info
Overfilling of the brake fluid reservoir is prevented.
I
Tighten the bleeder screw. Remove the bleeder bottle hose. Attach the protection
cap.
Disconnect the bleeding device. Remove the bleeder cover.
Correct the brake fluid level.
Guideline
*
T
Add brake fluid to level
0
5 mm (0.2 in)
M
Brake fluid DOT 4 (Pi p. 316)
! Position the cover with the membrane. Mount and tighten the screws.
Info
Clean up overflowed or spilled brake fluid immediately with water.
I
D00944-10
Check the hand brake lever for a firm pressure point.