How To Manage: Error Codes - AEG BBS8802B User Manual

Problems with Wi-Fi signal
Possible cause
Trouble with wireless network signal.
New router installed or router configuration
changed.
The wireless network signal is weak.
The wireless signal is disrupted by another mi‐
crowave oven placed near the appliance.

12.2 How to manage: Error codes

When the software error occurs, the display shows error message.
In this section, you will find the list of the problems that you can handle on your own.
Code and description
F111 - Food sensor is not correctly inserted in‐
to the socket.
F240, F439 - the touch fields on the display do
not work properly.
F601 - there is a problem with Wi-Fi signal.
F604 - the first connection to Wi-Fi failed.
F908 - the appliance system cannot connect
with the control panel.
When one of these error messages continues to appear on the display, it means a faulty
subsystem may have been disabled. In such a case contact your dealer or an Authorized
Service Centre. If one of these errors occurs, the rest of the appliance functions will continue to
work as usually.
TROUBLESHOOTING
Remedy
Check your wireless network and router.
Restart the router.
To configure appliance and mobile device
again, refer to "Before first use" chapter, Wire‐
less connection.
Move router as close to the appliance as possi‐
ble.
Turn off the microwave oven.
Remedy
Fully plug Food sensor into the socket.
Clean the surface of the display. Make sure
there is no dirt on the touch fields.
Check your network connection. Refer to "Be‐
fore first use" chapter, Wireless connection.
Turn the appliance off and on and try again. Re‐
fer to "Before first use" chapter, Wireless con‐
nection.
Turn the appliance off and on.
97/316