Cisco TelePresence SX10 Quick Set
Introduction
Video Selfview Default Mode
Define if the main video source (self-view) shall be displayed on screen after a call. The
position and size of the self-view window is determined by the Video Selfview Default
PIPPosition and the Video Selfview Default FullscreenMode settings respectively.
Requires user role: ADMIN, INTEGRATOR
Default value: Current
Value space: Off/Current/On
Off: Self-view is switched off when leaving a call.
Current: Self-view is left as is, i.e. if it was on during the call, it remains on after the call;
if it was off during the call, it remains off after the call.
On: Self-view is switched on when leaving a call.
Video Selfview Default PIPPosition
Define the position on screen of the small self-view picture-in-picture (PiP) after a call.
The setting only takes effect when self-view is switched on (see the Video Selfview
Default Mode setting) and fullscreen view is switched off (see the Video Selfview Default
FullscreenMode setting).
Requires user role: ADMIN, INTEGRATOR
Default value: Current
Value space: Current/UpperLeft/UpperCenter/UpperRight/CenterLeft/CenterRight/
LowerLeft/LowerRight
Current: The position of the self-view PiP will be kept unchanged when leaving a call.
UpperLeft: The self-view PiP will appear in the upper left corner of the screen.
UpperCenter: The self-view PiP will appear in the upper center position.
UpperRight: The self-view PiP will appear in the upper right corner of the screen.
CenterLeft: The self-view PiP will appear in the center left position.
CentreRight: The self-view PiP will appear in the center right position.
LowerLeft: The self-view PiP will appear in the lower left corner of the screen.
LowerRight: The self-view PiP will appear in the lower right corner of the screen.
D15330.16 SX10 Administrator Guide CE9.9, OCTOBER 2019.
Configuration
Peripherals
Maintenance
Video Selfview OnCall Mode
This setting is used to switch on self-view for a short while when setting up a call. The
Video Selfview OnCall Duration setting determines for how long it remains on. This applies
when self-view in general is switched off.
Requires user role: ADMIN, INTEGRATOR
Default value: On
Value space: Off/On
Off: Self-view is not shown automatically during call setup.
On: Self-view is shown automatically during call setup.
Video Selfview OnCall Duration
This setting only has an effect when the Video Selfview OnCall Mode setting is switched
On. In this case, the number of seconds set here determines for how long self-view is
shown before it is automatically switched off.
Requires user role: ADMIN, INTEGRATOR
Default value: 10
Value space: Integer (1..60)
Range: Choose for how long self-view remains on. The valid range is between 1 and 60
seconds.
www.cisco.com — Copyright © 2019 Cisco Systems, Inc. All rights reserved.
175
Administrator Guide
Device settings
Device settings
Appendices