Cisco TelePresence SX10 Quick Set Administrator's Manual page 96

Cisco TelePresence SX10 Quick Set

Introduction
Factory reset the video conferencing device
Factory reset using the reset button
We recommend that you back up the log files and configuration of
the device before you continue with the factory reset.
1. Lift the rubber flap on the back of the unit to uncover the reset
button (pin hole).
2. Use a paper clip (or similar) to press and hold the recessed
reset button until the screen turns black (approximately
10 seconds). Then release the button.
3. Wait while the device reverts to the default factory settings.
When finished, the device restarts automatically. This may
take a few minutes.
When the device has been successfully reset to factory
settings, the Setup assistant starts with the Welcome screen.
D15330.16 SX10 Administrator Guide CE9.9, OCTOBER 2019.
Configuration Peripherals
(page 3 of 3)
Maintenance Maintenance
Reset button (pin hole)
The recessed button can
be quite difficult to use.
You should feel the button
go down when pushed.
www.cisco.com — Copyright © 2019 Cisco Systems, Inc. All rights reserved.
96
Administrator Guide
Device settings Appendices
Lift the rubber flap
to uncover the reset
button (pin hole).