Manual Position - Honeywell HercuLink User Manual

Manual Position

Step
1
From the Home page, select the Manual Position prompt. Note: If the message "Operation Is
Prohibited" gets displayed, exit the manual positioning routine to return to the Home page
Main Menu. Select Configuration, Lockout and then select MAENAB. Set the MAENAB
function to ENAB. Return to the Home page Main Menu and select the Manual Position
prompt again. When entering into the manual positioning procedure, if the unit is currently in
AUTO mode, it will be placed into MANUAL mode.
Setup – Has no functionality in the manual positioning procedure.
Function – Sequences you through the manual positioning states.
Incr + 10% - Causes the motor to move 10% or 15 degrees up from its current position.
Decr – 10% - Causes the motor to move 10% or 15 degrees down from its current position.
Increment - Causes the motor to move 1% or 1 degree up from its current position.
Decrement - Causes the motor to move 1% or 1 degree down from its current position.
Close – Exits from the manual positioning procedure.
Note: If at any time question marks (?) are observed in both the upper and lower
displays, this is an indication that communications between the PDA and the unit have
been lost. To check communications, see Preparation on page 1.
2
The value shown on the top line is the current motor position. To move it in either direction
click one of the Inc / Dec buttons.
When the motor positioning has been completed, click the Function button. If the unit was in
AUTO mode before manual positioning was started, it will be placed back into AUTO mode. If
the unit was in MAN mode it will stay in MAN mode. Click Close button to return to Home
page.
ATTENTION: If you click Close button without clicking the Function button, the unit will remain
in MAN mode. To change to AUTO mode, go to Main menu, Configuration, Lockout, then select
MODE CHG.
Release 3
8/02
Action
HercuLink™ - User Manual
HercuLink

Manual Position

29