Table of Contents
Advertisement
Step
6
Click the Function button to access the Calibration Disabled state. Notice the only change in
the screen information is the upper and lower display lines. This lets you know what step of the
calibration process you're currently on.
7
Click the Function button to access the Begin Calibration state.
8
Click the Function button to access the Apply Input Zero calibration state.
9
Set the external DC voltage source to the low limit for the input type being calibrated.
Note: If at any time question marks (?) are observed in both the upper and lower
displays, this is an indication that communications between the PDA and the unit have
been lost. To check communications, see Preparation on page 1.
Release 3
8/02
Action
HercuLink™ - User Manual
HercuLink
Calibration
9
Advertisement
Table of Contents
