Display Setup-Cs On/Off - Honeywell S7800A Installation Manual

7800 SERIES S7800A KEYBOARD DISPLAY MODULE
Change Password
New Password: 000
Fig. 42. Change Password/New Password screen.
Use up/down arrows to change the numbers and left/right
arrows to move the cursor.
Press ENTER using the two ENTER buttons at the same time.
– Save Changes
– Exit no Save
Fig. 43. Save Changes/Exit no Save screen.
Use down arrow to save.
New Password Is: XXX
Use ENTER to Confirm
Fig. 44. New Password ls screen.
The following message will appear:
– Confirm
– Incorrect
Fig. 45. Confirm/lncorrect screen.
Use arrow for your selection. Choosing Confirm will take you
out of the DISPLAY Setup menu.
Press the left three buttons of the KDM for one second, then
release.
DISPLAY Setup
± PASSWORD
Fig. 46. DlSPLAY Setup/PASSWORD screen.
Use up/down arrows to change numbers and left/right arrows
to move the cursor to enter your new password.
Press ENTER using the two ENTER buttons at the same time.
The Select/Exit Screen (see Fig. 33) will appear. Choose
Select and you will be in the DISPLAY Setup menu. The
DISPLAY Setup/Select PASSWORD screen (see Fig. 41) will
appear. Press ENTER using the two ENTER buttons at the
same time.
The Select/Exit Screen (see Fig. 33) will appear. Choose Exit
and you will be out of the Setup menu again.
65-0090-6

Display Setup-CS ON/OFF

CS ON/OFF allows the Call Service Message to be as follows:
• OFF-No call Service Message displayed, normal 7800
SERIES lockout message displayed.
• ON-Customized Call Service Message displayed on 7800
SERIES lockout. Goes away when 7800 SERIES reset
button is pushed-just like a normal lockout.
• ON, Temporarily Off- Used for service technician to view
normal 7800 SERIES Lockout messages along with
diagnostic and history files. After 5 minutes, the display
goes back to the Call Service On mode.
DISPLAY Setup will appear. Enter your password if you have
changed the default password.
DISPLAY Setup
PASSWORD: 000
Fig. 47. DlSPLAY Setup/PASSWORD screen.
Press ENTER using the two ENTER buttons at the same time.
Select
Exit
Fig. 48. Select/Exit screen.
Choose Select.
DISPLAY Setup
Select: CLONE
Fig. 49. DlSPLAY Setup/Select CLONE screen.
Use the down arrow to scroll through the menu choices until
CS ON/OFF appears.
DISPLAY Setup
Select: CS ON/OFF
Fig. 50. DlSPLAY Setup/Select: CS ON/OFF screen.
Press ENTER using the two ENTER buttons at the same time.
Select
Exit
Fig. 51. Select/Exit screen.
Press Down arrow to Select.
28