Table of Contents
Advertisement
APPENDIX A
Display Setup
The S7800A Keyboard Display Module (KDM) requires a
password to enter the Display Setup Menu.
The Display Setup Menu offers the following functions:
- Clone-Allows the current display setup to be copied
entirely to another display (Series 3 or greater)-page
25.
- MB Address-Enables the ModBus Feature and Loca-
tion. The 7800 SERIES device is located on the Mod-
Bus highway. It also provides a means of system
verification that ModBus is active and that this module
is being addressed-page 26.
- MB Baud-Sets the data Transmit/Receive rate. The
S7800 is operating on ModBus-page 27.
- Clear All-Resets the Display settings back to the
factory settings-page 27.
- Password-Change current default password of 000 to
a unique one the customer has selected-page 27.
- CS On/Off-Allows the Customer Service message to
be displayed or the lockout message to be displayed-
page 31.
- CS Test-Allows the Customer Service message to be
viewed for accuracy. This will display just once-page
31.
- CS Edit-Allows for personalizing a Customer Service
message. Three screens of messages are available.
Each screen has two lines with 20 characters available.
See Table 9 for available character text-page 37.
Display Setup-CLONE
CLONE allows copying your entire Custom Display to
additional displays, Series 4 or higher.
Before you begin, you will want to build a cloning jig.
MASTER
1
2
3
4
5
203541 FIVE-WIRE
CONNECTOR
+
13 VDC POWER
SUPPLY (203968
FOR EXAMPLE)
Fig. 20. Cloning jig.
To access the CLONE menu:
Press the left three buttons of the KDM for one second, then
release.
SLAVE
1
2
3
4
5
203541 FIVE-WIRE
CONNECTOR
_
M22880
25
7800 SERIES S7800A KEYBOARD DISPLAY MODULE
DISPLAY Setup will appear. If you have a personal password,
enter it to enter Setup.
DISPLAY Setup
± PASSWORD: 000
Edit:
-
Fig. 21. Display Setup screen.
Press ENTER by pressing the two ENTER buttons at the same
time.
Select
Exit
Fig. 22. Select/Exit screen.
Choose Select.
DISPLAY Setup
Select: CLONE
Fig. 23. Display Setup/CLONE screen.
Press ENTER by pressing the two ENTER buttons at the same
time. The Select/Exit Screen (see Fig. 22) will appear. Choose
Select.
Clone Master: I am
Transmitting.
Fig. 24. Clone Master screen.
The Slave display will change from Fig. 25 to many On/Off
sweeps with periods of bright characters.
Waiting for
Connection . . .
Fig. 25. Waiting for Connection screen.
When complete, the Slave will still be going on and off, but the
Cloning Complete screen can be read (Fig. 26). Replace this
Slave with additional displays that need to be cloned.
BACK
ENTER
+
M22890
65-0090-6
Advertisement
Table of Contents
