Display Setup-Cs On/Off - Honeywell S7800A1167 Manual

7800 SERIES S7800A1167 KEYBOARD DISPLAY MODULE
Use the down arrow to scroll through the menu choices until
EAASSIGN appears.
Fig. 58. DISPLAY Setup/Select CEA ASSIGN screen.
Press ENTER using the two ENTER buttons at the same time.
Fig. 59. Select/Exit screen.
Choose Select.
Fig. 60. CEA Assign screen.
Use the up/down and left/right arrows to select terminal
number (7 for above example).
Press ENTER using the two ENTER buttons at the same time
to select.
Fig. 61. Select/Exit screen.
Choose Select.
Fig. 62. Assign screen.
Use the left/right arrow to move the cursor left and right. Use
the up/down arrows to change the message numbers (See
Table 8 for pre-set messages or use your custom description
from CEA EDIT. 32 is used from the above example.
The display will look like this:
Fig. 63. Assign T07 to msg 32 screen.
65-0311—02
Press the ENTER keys to accept.
Fig. 64. Save Changes/Exit no Save screen.
Press the Down arrow to save.
Fig. 65. CEA Assign/Assign screen.
Suggest that you record the terminal number and message
with your custom description. Repeat the above steps to map
the Expanded Annunciator terminals to your specific system.
When complete with your final message, press ENTER.
Fig. 66. Save/Exit screen.
Use the up arrow to select Exit.
Fig. 67. DISPLAY Setup/Select EAASSIGN screen.
Press ENTER then choose Exit.
Display Setup—CS ON/OFF
CS ON/OFF allows the Call Service Message to be as follows:
• OFF—No call Service Message displayed, normal 7800
SERIES lockout message displayed.
• ON—Customized Call Service Message displayed on 7800
SERIES lockout. Goes away when 7800 SERIES reset
button is pushed—just like a normal lockout.
• ON, Temporarily Off— Used for service technician to view
normal 7800 SERIES Lockout messages along with
diagnostic and history files. After 5 minutes, the display
goes back to the Call Service On mode.
DISPLAY Setup will appear. Enter your password if you have
changed the default password.
Fig. 68. DISPLAY Setup/PASSWORD screen.
Press ENTER using the two ENTER buttons at the same time.
30