Honeywell Xtralis FAAST FLEX FLX-010 Product Manual page 28

FAAST FLEX
Action
Place unit in TEST Mode
Initiate CHANGE PASSWORD
procedure
(Passcode Authentication
Required - if not authenticated,
you must enter the passcode to
start procedure.)
6.3.1 Authenticating - Entering Passcode
Caution: THE DEFAULT PASSCODE IS 000000 AND IT MUST BE CHANGED DURING DEVICE
COMMISSIONING! BE SURE TO RECORD THE NEW PASSCODE IN ACCORDANCE
WITH YOUR LOCAL POLICIES.
Overview
Certain actions related to operation and configuration of the FAAST FLEX are protected by use of a six digits
passcode. To enter the passcode, the user must press the SILENCE/+ or TEST/- buttons to enter the six
digits of the passcode. Once the digit has been entered, press the ENTER button to confirm the digit. For
example, to enter a 3 you would press the SILENCE/+ button three times. If you pressed the SILENCE/+
button four times, and then pressed the TEST/- button once, that would also register as a 3. Once all six digits
have been entered, press the ENTER button again to confirm entry.
Button
SILENCE/+
TEST/-
RESET
ENTER
Access to some functions requires a passcode. Follow these steps to enter the passcode (see Figure 6-2):
Note: Passcodes are 6 digits long and digits from 0 to 9 are valid.
1. When you access a function that requires authentication, LED 1 will blink yellow waiting for the first digit
(60 seconds timeout to cancel operation).
2. Using the SILENCE/+ or TEST/- buttons, enter the first digit of the passcode.
3. Press the ENTER button to confirm the first digit. LED 1 will be steady yellow and LED 2 will blink slow
yellow. If not preceded with SILENCE/+ or TEST/- buttons, the digit will be 0.
4. Repeat the process until all six digits of the passcode have been entered.
5. After the sixth digit has been entered press enter to confirm and if the passcode is correct all six LEDs
will show steady green for 3 seconds. If the passcode is incorrect, all six LEDs will show steady red for 3
seconds and the process must be restarted.
www.xtralis.com
Button
Short
Press
Long
Press
Increments the current digit (if smaller than 9).
Decrements the current digit (if greater than 0).
Cancels changes to the current digit entry and prompts for the user to re-
enter the digit.
Confirms the current digit and the corresponding LED shows yellow.
If all six digits have been confirmed and are correct, all LEDs will show
green. If incorrect, all LEDs will show red for 3 seconds.
FAAST FLEX Product Guide
LED Display
See section 6.3.8 Test
Mode for more information
LEDs 1 through 4 will show
yellow to indicate that the
CHANGE PASSWORD
procedure has started. See
section 6.3.2 Changing the
Passcode for more
information.
Action(s)
Description
21