FAAST FLEX Product Guide
3.2
Mounting the Unit
The FAAST FLEX is mounted on any wall or flat surface that is conveniently located for access to the piping
and electrical connections. It can be mounted in the standard orientation or inverted 180°. Once the proper
location has been determined, mount the device as follows:
Note:
The FAAST FLEX can be mounted with either two or four screws, depending on your specific
requirements.
1. The cover of the box FAAST FLEX, a template for the mounting holes is provided (see Figure 3-2).
2. Use the template to mark the locations for the mounting holes, ensuring that all piping and electrical
connections are located properly.
3. Drill appropriate pilot mounting holes for M4 screws in the locations designated by the template.
4. Loosely install a screw in the Hole 1 location.
5. Position the FAAST FLEX in place over the mounting screw in Hole 1 (Figure 3-3) , and slide it down into
place.
6. Install a mounting screw in Hole 2.
7. Tighten the two mounting screws, taking care not to overtighten. Over tightening the screws can damage
the device.
8. Optionally, install mounting screws in Holes 3 and 4.
9
Figure 3-2: Mounting Template
FAAST FLEX
1
USE AS TEMPLATE
TO DRILL MOUNTING
HOLES
www.xtralis.com