Cine Mode - GE Voluson S6 Basic User Manual

Note
Note

6.3 Cine Mode

Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4
6. To change the Zoom factor, turn the [Zoom] digipot.
Remarks:
•
In the overview image the zoom box is depicted with a yellow border and is identical with
the zoomed sector on screen. Using read zoom has not effect whatsoever on the zoom
box in the overview image.
•
The overview window is available in Full Screen, Quad Screen and Dual Screen and in
the following modes: B-Mode, CF mode, PD mode, HD-Flow, B-Flow and Contrast.
•
The overview window is not displayed in following modes: PW mode, CW mode, M-
Mode and 3D/4D Mode. If one of these modes is activated, the overview window is
hidden. If the mode is deactivated again, the overview window appears again.
All adjustments (Zoom on/off, Overview Image size and position, Zoom Box pos/size, etc.) are
only applied to the currently active screen (green Voluson® S6/S8 Logo) and to all new
screens (updated after adjustment).
In Power Doppler, Color Doppler and HD-Flow mode the box size and the box position of
Zoom box is the same as the Color box size +10%. When the box size or box position is
changed, the Color box and zoom box are adjusted so that above relation remains constant.
The Zoom box is linked with the color box (changes caused by steering such as steering angle
or box size cause the same changes in the zoom box.) Color is only visible in the overview
window if it was turned on before HD Zoom was activated. Color does not move in the
overview image.
•
In HD Zoom the overview image is not updated. It is the last image before HD Zoom was
activated.
•
In Pan Zoom the Overview image is updated with every frame. Gray/Chroma adjustment
also affects Overview Image
7. Press the [Zoom] digipot to exit the High Resolution Zoom function.
While scanning a certain number of frames (2D images of the last examination sequence), this
will be stored in the cine memory automatically. This is indicated by the green bar in the
bottom left corner:
mode, by pressing the [Freeze] key or the defined [Px] key, the cine memory will be stored as
a sequence. This sequence can be reviewed in loop mode or image by image. After the cine
clip is stored the cine memory will be deleted.
2D Mode
When entering freeze
6-15