Table of Contents
Advertisement
Setting the RF UNIT
80
General Setup Information
if you connect a TV or color monitor equipped with A/V input jacks, skip this
adjustment.
Why this setting is necessary:
You must set the RF UNIT selector at the rear of the VCR properly so that your
TV can receive the correct signal from the VCR. Set the selector to 3 CH (Ch
3) or 4 CH (Ch 4), whichever is not active in your area.
1 Set the RF UNIT at the rear of the VCR to 3 CH or 4 CH, whichever is
not used in your area.
| 2 Press POWER.
The power indicator lights up on the front panel.
3 Press TV/VTR.
The VTR indicator lights up in the display window.
| Note:
|
For details on adjusting TV channels, see your TV instruction manual.
l
Advertisement
Table of Contents
