Preparing The Remote Commander; Inserting Batteries; Setting The Command Mode - Sony Hi8 EV-S3000 Operating Instructions Manual

Preparing the Remote Commander
1
COMMAND MODE
—— |
VTR1 ' VTR3
VTR2
Note:
When you insert the batteries
into the Remote Commander,
the indication "VTR 2" appears
in the LCD panel. That tells you
that the command mode setting
of the Remote Commander is
set to "VTR 2".
1
Inserting Batteries
Open the lid.
2 Insert two size AA (IEC designation R6) batteries with the polarity lined up
correctly.
3 Close the lid.
_
Notes on the handling of batteries
With normal use, the batteries should last for approximately six months.
If you do not use the Remote Commander for an extended period of time, remove
the batteries to avoid possible damage from battery leakage.
Do not use a new battery together with an old one. Do not use different types of
batteries.
Setting the Command Mode
You can select three different positions for the Command Mode setting.
Set the COMMAND MODE VTR 1/2/3 selector on the rear panel of the VCR to
VTR 2.
Press the COMMAND MODE button on the Remote Commander to display VTR 2
in the LCD panel. When you insert the batteries into the Remote Commander, the
indication "VTR 2" appears.
Controlling Other Sony Video Equipment
Press the Remote Commander COMMAND MODE button to display VTR 1 or VTR
3, a position other than the one you selected for this VCR.
Set the COMMAND MODE selector of any other video equipment to the same
position you selected in step 1.
If other Sony video equipment does not have a COMMAND MODE selector,
you can control such equipment using the following settings:
Infrared remote controlled Sony Betamax VCRs: VTR 1
(Some of them may not be controlled in this mode.)
Sony 8mm format VCRs: VTR 2
Sony VHS format VCRs: VTR 3
Preparing the Remote Commander 23