Table of Contents
Advertisement
Quick-Timer Recording
¢
ff your cassette ends
during quick-timer
recording
Recording stops and the
VCR turns off. The cassette
will not rewind automatically.
¢
Ifa power interruption
occurs during quick-timer
recording
Recording will stop and your
VCR will turn off. If the
interruption lasts fess than
one hour and the power is
restored before the recording
end time, recording will start
again from that point.
56
Quick-Timer Recording
This feature lets you record programs without going through the entire timer
setting procedure, Note, however, that it provides only an approximate setting
for the program you wish to record.
Before you begin
*
Make sure that the clock has been set correctly.
¢
Check to see that the TIMER REC indicator is not lit in the display window of
the VCR.
Operation
If you're currently recording, skip to step 7.
1 Insert a cassette into your VCR.
2 Press INPUT SELECT to light the TUNER in the display window.
3 Select the desired recording speed (SP or LP) by pressing TAPE SPEED inside
the front panel.
4 Press QUICK TIMER on the VCR.
If you insert a cassette with the safety tab slid out, your VCR will eject the
cassette.
5 Select the channel you wish to record using CHANNEL/INDEX +/-.
The channel can be changed while the channel indicator is blinking (for about 30
seconds).
6 Press QUICK TIMER again to start recording.
7 Select the recording duration by pressing QUICK TIMER to change the duration
indicator in the display window.
Each time you press QUICK TIMER, the recording duration increases by 30
minutes (up to 5 hours).
0:00
———> 0:30 ———> 1:00
5:00 <—
Once recording has finished, your VCR will turn off automatically.
During quick-timer recording, the recording time can be changed by pressing the
QUICK TIMER button. During recording, the time displayed will count down in the
units of one minute.
To stop quick-timer recording:
To stop quick-timer recording while a program is being recorded, press TIMER
REC ON/OFF.
Advertisement
Table of Contents
