Kenwood NEXEDGE NX-200 Function Reference page 597

APPENDIX
Installing the Transceiver in a Vehicle (Mobile Only)
Installing the Transceiver
For passenger safety, install the transceiver securely using the mounting bracket and screw set so the transceiver will not break
loose in the event of a collision.
1
Attach the mounting bracket in the dash.
1) Mark the position of the holes in the dash by using the mounting bracket as a template.
2) Drill the marked holes by using the electric drill.
3) Attach the mounting bracket using flat washers, spring washers, and self-tapping screws (4 of each).
Be sure to mount the transceiver in a location where the controls are within easy reach of the user. Also, be sure to mount the
transceiver in a location where there is a sufficient space at the rear of the transceiver for cable connections.
2
Connect the antenna to the antenna connector.
3
Connect the DC power cable to the power input connector.
4
Slide the transceiver into the mounting bracket and secure it using hex-headed screws with washer (2
each for the left and the right).
5
Mount a microphone hanger in a location where it will be within easy reach of the user.
The microphone and microphone cable should be mounted in a location where it will be not interfere with the safe operation of
the vehicle.
Antenna connector
Power input
DC power cable
The fuse in the DC power cable is 15 A. When replacing the fuse, be sure to replace it with a 15 A fuse.
FUNC (K)/Ver 4.00
Hex-headed screws
with washer
connector
Ignition sense cable
Black (-) cable
Red (+) cable
Flat washer
Spring washer
Self-tapping screw
Fuse
Microphone
Mounting bracket
12V vehicle
battery
CONTENTS INDEX 563