Kenwood NEXEDGE NX-200 Function Reference page 340

12 FleetSync
12.3 Transmitting/ Receiving a PTT ID
The timing to send the PTT ID can be configured for each channel or GID using KPG-111D/ DN.
Configuration
Off No PTT ID is sent.
Own Fleet (Own) and ID (Own) are sent as the PTT ID when the PTT switch of the transmitting transceiver is
BOT
pressed.
Own Fleet (Own) and ID (Own) are sent as the PTT ID when the PTT switch of the transmitting transceiver is
EOT
released.
Both Own Fleet (Own) and ID (Own) are sent as the PTT ID at the timing of both BOT and EOT.
The transceiver initiates a Selcall using the FleetSync ID configured in the ID List for FleetSync by pressing the
List PTT switch on the transmitting transceiver. The FleetSync ID to be sent can be selected from the ID List by using
KPG-111D/ DN.
Configuration using KPG-111D/ DN
• Configuring the PTT ID (Analog) (Conventional) (
• Configuring the ID List Number of the FleetSync ID to be sent (
• Configuring the PTT ID (Analog) (LTR Trunking System) (
• Configuring the ID List Number of the FleetSync ID to be sent (
Displaying the ID of the Communicating Caller on the LCD (Caller ID Display)
Caller ID Display is the function to display the received PTT ID on the main display.
A user can identify the caller not only by voice, but also through the display.
When the transceiver receives a PTT ID, the received ID, ID Name, or ID List number appears on the main display.
If the received ID is not configured for ID List in FleetSync, the ID will appear.
If the received ID is configured for ID List in FleetSync, the corresponding ID Name will appear. However, if the received ID
is configured for ID List in FleetSync but the ID Name is not configured, the ID List number will appear.
Upon the elapse of the time configured for Auto Reset Timer or by a user pressing one of the keys of the transceiver, the
main display reverts to the channel or GID display.
PTT ID appears with muting active when a PTT ID is received even if the conditions for unmuting are not satisfied.
Note
• A user cannot reply to an ID on the transceiver while the ID appears on the main display.
• The PTT ID is displayed even if the transceiver receives either BOT or EOT.
• If the QT tone and DQT code are preconfigured for the transceiver, the Caller ID Display function will be activated even if the received
QT tone or DQT code does not match the QT tone or DQT code preconfigured for the transceiver.
• This function is unavailable for NX-200S/ NX-300S.
Configuration using KPG-111D/ DN
Configuring the Caller ID Display to be enabled or disabled (
FUNC (K)/Ver 4.00
Table 12-2 Timing to Send the PTT ID
Description
FPRG 8.3.3 Page 1 Tab)
See
See
See FPRG 8.16.2 General 1 Tab)
FPRG 8.3.3 Page 1 Tab)
See
FPRG 8.7.8 PTT ID (Analog))
FPRG 8.7.9 ID List Number (Analog))
See
CONTENTS INDEX 306