Kenwood NEXEDGE NX-200 Function Reference page 232

9 NXDN TRUNKING SYSTEM
9.2 Control Channel Hunt
2
Press and hold the
Search Mode Tone sounds from the transceiver, and then the
transceiver will start the Forced Search.
The transceiver leaves the acquired control channel and starts
the hunt sequence, and then the transceiver proceeds to search
for another control channel using the Preferential Hunt
Sequence. If a control channel is found, the transceiver migrates
to that control channel. In such a case, the transceiver is in the
standby state after processing an acquisition of control channel. If
no control channel is found, the transceiver continues the hunt
sequence.
Note
Transceiver operation is identical even if "Forced Search" is
selected after entering Menu Mode by pressing the Menu key.
(Refer to 3.4 Using Menu Mode on page
Note
• The transceiver cannot receive a call while the transceiver is performing the Forced Search.
• The Forced Search cannot be used if Site Lock is enabled on the transceiver. However, the site number can be displayed.
Configuration using KPG-111D/ DN
Assigning functions to the PF keys on the transceiver (
FUNC (K)/Ver 4.00
Forced Search key.
23.)
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
See FPRG 8.12 Key Assignment Window)
Mobile
CONTENTS INDEX 198