Table of Contents
Advertisement
MA-LCD Repeater / Zonal Mimic
Do not try to use the control unit and connected devices without reading this manual.
1
DETECTION SYSTEM LIMITS
An alarm or fire detection system can be very useful for providing a prompt warning of any dangerous events,
such as fires, a robbery or a simple burglary, and in some cases, it can automatically manage events (transmit
messages for room evacuation, automatic fire-extinguishing, CCTV system interface, access route or door
blockage, automatic warning to authorities, etc.), but it does not ensure protection against damage to property
or damage caused by fires or robberies).
In addition, systems may not operate properly if they are not installed and maintained according to the
manufacturer's instructions.
1.1 PRECAUTIONS
•
These instructions contain procedures to be followed in order to avoid damage to
equipment. It is assumed that the user of this manual has completed a training course and
that he knows the applicable rules that are in force.
•
The system and all its components must be installed in an environment with the following
conditions:
–
Temperature: -5°C ... +40°C.
–
Humidity: 10% ... 93% (non-condensing).
•
Peripheral devices (sensors, etc.) which are not perfectly compatible with the control unit
may cause damage to the control unit, or cause the system to malfunction at any time. It is
therefore essential to only use material which is guaranteed by Honeywell and is compatible
with its control units.
•
Please consult Honeywell Technical Service if in any doubt.
•
This system, like all solid-state components, may be damaged by induced electrostatic
voltages: handle the boards by the edges and avoid touching the electronic components.
•
In any case, appropriate earthing ensures a reduction in sensitivity to disturbances.
•
Please consult Honeywell Technical Service if you cannot solve installation problems.
•
No electronic system will operate if it is not supplied with power.
•
If the mains power supply fails, the system will still operate using battery power, but only for
a limited period.
•
During the system planning phase, consider the authority required to ensure the power
supply and batteries are appropriately dimensioned.
•
Skilled personnel must periodically check the condition of batteries.
•
Disconnect the MAINS and the batteries BEFORE removing or inserting any board.
•
Disconnect ALL power supply sources from the control unit BEFORE performing any
servicing.
•
The control unit and the connected devices (sensors, modules, repeaters, etc.) may be
damaged if a new board is inserted or removed, or if the powered cables are connected.
•
The most common cause of malfunctions is inappropriate maintenance.
•
Pay particular attention to these aspects from the start of the system planning phase; this
will facilitate future servicing and will reduce cost.
This panel bears the CE marking to indicate conformity with the following European Directives:
EMC Directive 2004/108/EC and LVD Directive 2006/95/EC.
4
M-167.6-MA-LCD-EN / 10.2023
Advertisement
Table of Contents
