Wayne-Dalton 800FR Installation Instructions Manual page 31

Face mounted rolling steel storm shelter door with non-tension release automatic closure governor controlled
Table of Contents

Advertisement

Final Door Install (continued)
STEP 34
PRODUCT SAFETY INSTRUCTIONS
The door installer has the following responsibilities:
• Find labels in hardware box.
• Attach Product Safety Label 273491 and 830877 as directed on each label.
• Demonstrate to the door user the correct way to control the closing speed of the
rolling door with crank, hand chain or push-up operation; show that two hands
should be used to control the hand chain.
• Inform the door user of the following recommendations per ANSI Z535.4: "Product
safety labels should be periodically inspected and cleaned by the product user as
necessary to maintain good legibility. " The product user should regularly clean each
label surface to maintain legibility or order replacement safety labels from the door
manufacturer as required to maintain legibility.
• Electric operators must be installed on the door in accordance with the instructions
from the manufacturer of the operator.
• Doors with sensing edge must have Safety Label 607873 attached to the bottom bar
and at eye level on the drive side guide or jamb.
830872-0001
REV 12/07/2022
WARNING
WARNING
MOVING door could
result in death or serious
Fire door could close
injury.
RAPIDLY at any time
Do NOT close door until
and result in death or
doorway is clear.
serious injury.
SAFETY INSTRUCTIONS
DO NOT stand in
doorway.
1. Control the speed of the door
during manual operation.
SAFETY INSTRUCTIONS
2. Do not stand or walk under
moving door.
1. DO NOT block / wedge
3. Keep doorway clear and in full
door open.
view while operating door.
2. Conditions that prevent
4. Do NOT permit children to play
normal or emergency
on, near, or with door or to operate
operation must be corrected
controls.
immediately.
5. Unlock door before opening
door.
3. Repair parts must be
6. Sensing devices on motor
obtained from the door
operated doors should be tested
manufacturer per NFPA 80.
frequently.
4. Use manufacturer's
7. Adjustments or repairs must be
instructions to inspect and
made by a trained door systems
drop test fire door. Door
technician using proper tools and
automatic closing device
instructions.
may be damaged if drop test
8. Visually inspect door and
occurs with door closed.
hardware monthly for worn and/or
5. Annual tsting is required
broken parts and check to see if
by NFPA80 and building
door operates freely. DO NOT
codes.
operate a door with a broken
spring.
Place label at a readable height on
door drive side guide or jamb.
Place label at a readable height on
door drive side guide or jamb.
DO NOTE remove, cover, or paint
over label.
Do NOT remove, cover, or paint
over label.
Product user should inspect this
label periodically for legibility, and
This label should be inspected
should order a replacement label
from the door manufacturer as
periodically for legibility, and a
needed.
replacement label should be
ordered from the door manufac-
turer as needed.
09/29/2022
830877-0001
05/12/2022
273491 REV A
©Copyright 2022 Wayne Dalton, a division of Overhead Door Corporation
STEP 35
BOTTOM BAR WARNING DECAL
Doors with sensing edge on the bottom bar must have the warning decal shown
below mounted on the bottom bar and at eye level on the drive side guide or jamb.
STEP 36
HAND CHAIN KEEPER
Hand chain operated doors are provided without a hand chain "keeper" provided
with rolling service doors; this type chain keeper MUST NOT be installed on rolling
fire doors. The hand chain must not be used to hold the fire door in the open position
because this could prevent the fire door closing during a fire emergency. For safety
reasons the hand chain may be held out of the opening by a wire loop fastened to a
wall with the hand chain hanging inside the loop.
STEP 37
CHAIN AND RELEASE CABLE STORAGE
Electric operators have a hand chain and release cables hanging below the operator
in the opening. For safety reasons the hand chain and release cables may be stowed
in a bag below the operator, or held out of the opening by a wire loop fastened to a
wall with the hand chain hanging inside the loop.
31

Advertisement

Table of Contents
loading

Table of Contents