Honeywell ULTAMAX PRO FC20 User Manual page 10

GETTING STARTED (CONTINUED)
Charge Base and Accessory Storage Assembly
Place the accessory holder 1 and 2 in the direction of the arrow on (Fig.4) and
push them against the charging base. You will hear a "click" once they are installed
properly.
4
Accessory
holder 1
Charging base
Placing the Machine in to The Charge Base
Placing the machine into the charge ensuring it seats properly on the base pin
module as shown on (Fig.5). When using the product, pick up the machine by
holding the handle and lifting it up out of the charge base.
Installation and Removal of Dirty Water Tank
To remove the dirty water tank, hold the machine, hold the dirty water tank handle
with the other hand, and then press the dirty water tank release button with your
thumb to remove the dirty water tank; to install the dirty water tank, first you
should insert the bottom of the dirty water tank into the machine body, and then
press the dirty water tank until a click is heard in the body, at this moment, it
means the installation is successful. (Fig.6)
5
Accessory
holder 2
Rear charge slot
Base pin
module
EN | 10
6
Dirty water
tank release
button