Makita DUH606 Instruction Manual page 11

10. Tighten the bolts to fix the shear blades.
Fig.14
► 1 . Bolt
11. Attach the felt pad to the shear blades.
Fig.15
► 1 . Felt pad
12. Attach the plate.
Fig.16
► 1 . Plate
13. Attach the cover, and then tighten 6 bolts.
1
Fig.17
► 1 . Bolt 2. Cover
NOTICE:
smoothly, the shear blades are not engaged with
the crank properly. Install the shear blades again.
1
NOTICE:
blades such as the crank is worn out, ask Makita
Authorized Service Centers for parts replacement
or repairs.
Installing or removing the chip receiver
Optional accessory
CAUTION:
chip receiver, always wear gloves so that your
hands do not directly contact the shear blades.
NOTICE:
the chip receiver is installed on the tool. Before
carrying or storing the tool, uninstall the chip
receiver, and then install the blade cover to avoid
blade exposure.
NOTICE:
before installing the chip receiver.
The chip receiver gathers discarded leaves and makes
1
clean-up afterward much easier. It can be installed on
either side of the tool.
1.
Align the holes on the chip receiver with the
screws on the shear blades.
1
Fig.18
► 1 . Screw
11 ENGLISH
1
If the shear blades do not move
If the parts other than the shear
When installing or removing the
The blade cover cannot be installed if
Be sure to remove the blade cover
2