Noise Read instruction manual. The typical A-weighted noise level determined accord- ing to EN62841-4-2: Do not expose to moisture. Model DUH604S Sound pressure level (L ) : 79.3 dB(A) Sound power level (L ) : 90.3 dB (A) Beware of pinching.
The vibration total value (tri-axial vector sum) deter- any power switch. Proper carrying of the hedge mined according to EN62841-4-2: trimmer will decrease the risk of inadvertent start- Model DUH604S ing and resultant personal injury from the blades. Vibration emission (a ) : 2.5 m/s...
Page 10
Work gloves of stout leather are part of the Do not dispose of the battery(ies) in a fire. The basic equipment of the tool and must always cell may explode. Check with local codes for be worn when working with it. Also wear possible special disposal instructions.
Only for battery cartridges with the indicator causing fires, personal injury and damage. It will ► Fig.2: 1. Indicator lamps 2. Check button also void the Makita warranty for the Makita tool and Press the check button on the battery cartridge to indi- charger.
Overheat protection for tool or NOTE: Depending on the conditions of use and the ambient tem- battery perature, the indication may differ slightly from the actual capacity. NOTE: The first (far left) indicator lamp will blink when There are two types of overheating; tool overheating the battery protection system works.
Page 13
Remove four screws (for DUH604S) or five screws Reverse button for debris removal (for DUH754S), and then remove the chip receiver from the tool. WARNING: ► Fig.7: 1. Chip receiver 2. Screw If the entangled branches or debris cannot be removed by the reverse func-...
Pull the front switch trigger, then pull 18. Attach the chip receiver to the tool by tighten- ing four screws (for DUH604S) or five screws (for the rear switch trigger while pressing the lever, and then move the tool forward.
Shear blade maintenance Grease lubrication Before the operation or once per hour during operation, Interval of lubrication: Every 100 operating hours apply low-viscosity oil (machine oil, or spray-type lubri- Remove the bolt from the hole for lubrication. cating oil) to the shear blades. ►...
Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the manual, do not attempt to dismantle the tool. Instead, ask Makita Authorized Service Centers, always using Makita replace- ment parts for repairs.