Installing A Front Option - ABB ACS480-04-09A8-1 Hardware Manual

112 Electrical installation – North America
• Side option: Multifunction extension module slot on the side of the drive.
Refer also to the applicable fieldbus module manual for the installation instructions. For
other option modules, refer to:
• BREL-01 relay output extension module (page 233)
• BAPO-01 auxiliary power extension module (page 223)
• BIO-01 I/O extension module (page
￭

Installing a front option

WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or death,
or damage to the equipment can occur. If you are not a qualified electrical
professional, do not do installation or maintenance work.
1. Do the steps in section
work.
2. Remove the screw on the drive front cover and lift the front cover up.
3. If the option module has a locking tab, pull it up.
4. Carefully align the option module with the option module slot and push it into position.
5. Torque the screw to 0.5 N·m (4.4 lbf·in).
6. If the option module has a locking tab, push it down until it locks.
7. Connect the control cables. See the control cable connection instructions.
227).
Electrical safety precautions (page 18)
2
before you start the
2