Rear Panel - Cisco 4200 Series Hardware Installation Manual

Rear Panel

Rear Panel

The following figure shows the rear panel of the Secure Firewall 4200.
Figure 7: Secure Firewall 4200 Rear Panel
1
3
5
7
9
11
Power Switch
Note
Cisco Secure Firewall 4200 Series Hardware Installation Guide
14
Power on/off switch
Dual fan modules (FAN-1, FAN-2, FAN-3) LEDs
Power supply module 1 (PSU-1)
Dual fan module 1 (FAN-1)
Dual fan module 3 (FAN-3)
Power supply module 2 (PSU-2) connector
The power switch is located to the left of PSU-1 on the rear of the chassis. It is a toggle switch that
controls power to the system. Turning the switch to OFF starts the graceful shutdown process. During
the shutdown process the power LEDs flash green indicating that the process has started. Once the
shutdown is complete, the system is powered off. Wait for the system power LEDs to turn off before
unplugging the AC power cables. See
Threat defense requires a graceful shutdown. See the
procedure.
2 Power supply LED (PSU-1)
4 System power LED
This system power LED has the same behavior
as the front panel LED. See
on page 11
Note
Power supply module 1 (PSU-1) connector
6
8 Dual fan module 2 (FAN-2)
10 Power supply module 2 (PSU-2)
—
Front Panel LEDs, on page 11
Cisco Secure 4200 Getting Started Guide
Overview
Front Panel LEDs,
for more information.
Power supply module 1 (PSU-1)
for the power status LED description.
for the