Cisco 4200 Series Hardware Installation Manual page 27

Overview
Note Make sure you have the correct firmware package and software version installed to support this network
module. See the configuration guide for your software for the procedures for updating the firmware package
and verifying the software version. See the
the
including operating system and hosting environment requirements, for each supported version.
The following figure shows the front panel of the 8-port 1000Base-Tnetwork module.
Figure 12: 8-Port 1000Base-T Network Module (FPR-X-NM-8X1GF)
1 Bypass LEDs B1 through B4
3 Ethernet 2/3 and Ethernet 2/4 or Ethernet 3/3 and
3/4
Ports 3 and 4 are paired together to form a
hardware bypass pair. LED B2 applies to this
paired port.
Cisco Secure Firewall ASA Compatibility
• Green—In standby mode.
• Amber, flashing—Port is in hardware bypass
mode, failure event.
8-Port 1000Base-T Network Module with Hardware Bypass
Cisco Secure Firewall Threat Defense Compatibility Guide
guide, which provide Cisco software and hardware compatibility,
2 Ethernet 2/1 and 2/2 or Ethernet 3/1 and 3/2
Ports 1 and 2 are paired together to form a
hardware bypass pair. LED B1 applies to this
paired port.
4 Ethernet 2/5 and 2/6 or Ethernet 3/5 and 3/6
Ports 5 and 6 are paired together to form a
hardware bypass pair. LED B3 applies to this
paired port.
Cisco Secure Firewall 4200 Series Hardware Installation Guide
and
23