Cisco 4200 Series Hardware Installation Manual page 36

Supported SFP/SFP+/QSFP+ Transceivers
Warning
Statement 1055 Class 1/1M Laser
Invisible laser radiation is present. Do not expose to users of telescopic optics. This applies to Class 1/1M
laser products.
Warning
Statement 1056 Unterminated Fiber Cable
Invisible laser radiation may be emitted from the end of the unterminated fiber cable or connector. Do
not view directly with optical instruments. Viewing the laser output with certain optical instruments, for
example, eye loupes, magnifiers, and microscopes, within a distance of 100 mm, may pose an eye hazard.
Warning Statement 1057 Hazardous Radiation Exposure
Use of controls, adjustments, or performance of procedures other than those specified may result in
hazardous radiation exposure.
Warning
Use appropriate ESD procedures when inserting the transceiver. Avoid touching the contacts at the rear, and
keep the contacts and ports free of dust and dirt. Keep unused transceivers in the ESD packing that they were
shipped in.
Caution
Although non-Cisco SFPs are allowed, we do not recommend using them because they have not been tested
and validated by Cisco. Cisco TAC may refuse support for any interoperability problems that result from
using an untested third-party SFP transceiver.
The following table lists the supported transceivers for the fixed ports on all 4200 models, and the
FPR4K-XNM-8X10G and FPR4K-XNM-8X25G network modules.
Table 3: Supported 1-Gb SFP Transceivers
Optics Type
1G, 1000Base-T
1G multimode
1G single mode
1G SM extended r.
1G SM
Cisco Secure Firewall 4200 Series Hardware Installation Guide
32
PID
GLC-TE
GLC-SX-MMD
GLC-LH-SMD
GLC-EX-SMD
GLC-ZX-SMD
Overview
Comments
1 Gb-copper SFP version
850 nm
1310 nm
40 km
80 km