Front Panel - Cisco TelePresence SX80 Installation Manual

Installation guide for Cisco TelePresence SX80

Front panel

Shutdown
78-100153-03A0rev1 | SEPTEMBER 2019 | © 2019 Cisco Systems, Inc. All rights reserved.
Front panel LEDs
Power Blinks when the system is
starting up.
Steady light when the
codec is ready for use.
Pulsates when the codec is
in standby.
In Call Steady light when in call.
IR Not in use.
Alarm Lights steady when a
serious error occurs.
Attach rubber feet or mount the codec in a rack
Place the codec on a plane surface, or mount it in a standard rack.
On a plane surface
Attach the provided rubber feet on the bottom of the codec.
Place them in the recess in each corner.
In a standard rack
Fasten the provided rack ears to the codec using four screws.
The screws are pre-mounted in the codec. Use the Allen key to
remove the screws, put the rack ears in place, and fasten them
with the same screws (see illustration).
Fasten the codec with rack ears to the rack with screws
matching your rack (not provided).
Allen key, 2 mm
2