Figure 22 - Loading Ac Termination Enable And Write Protector Jumper For Modbus (Rs-485); Table 25 - Ac Termination And Write Protector Jumpers For Modbus - Honeywell SMV800 SmartLine User Manual

Figure 22 – Loading AC termination enable and write protector jumper for Modbus (RS-485)
Table 25 – AC Termination and write protector jumpers for Modbus
If applicable, re-install the Display module as follows:
•
•
•
NOTE: Installing a Display Module into a powered transmitter may cause a temporary upset
to the loop output value.
Orient the Display for proper viewing through the end cap window by
mounting Display Module in 90
Revision 10
Jumper
Arrangements
AC termination = OFF (Disabled)
Write Protect = OFF (Not Protected)
AC termination = ON (Enabled)
Write Protect = OFF (Not Protected)
AC termination = ON (Enabled)
Write Protect = ON (Protected)
AC termination = OFF (Disabled)
Write Protect = ON (Protected)
Orient the display as desired.
Install the Interface Connector in the Display module such that it will mate
with the socket for the display in the Communication module.
Carefully line up the display and snap it into place. Verify that the two tabs on
the sides of the display latch.
o
SMV800 Transmitter User's Manual
Description
increments.
Page 59