Honeywell S7800A1167 Manual page 28

7800 SERIES S7800A1167 KEYBOARD DISPLAY MODULE
The Select/Exit Screen (see Fig. 33) will appear. Choose
Select.
The DISPLAY Setup/Select CLONE screen (see Fig. 23) will
appear. Use the down arrow to scroll through the menu
choices until PASSWORD appears.
Fig. 41. DISPLAY Setup/Select PASSWORD screen.
Press ENTER using the two ENTER buttons at the same time.
Fig. 42. Change Password/New Password screen.
Use up/down arrows to change the numbers and left/right
arrows to move the cursor.
Press ENTER using the two ENTER buttons at the same time.
Fig. 43. Save Changes/Exit no Save screen.
Use down arrow to save.
Fig. 44. New Password Is screen.
The following message will appear:
Fig. 45. Confirm/Incorrect screen.
Use arrow for your selection. Choosing Confirm will take you
out of the DISPLAY Setup menu.
Press the left three buttons of the KDM for one second, then
release.
Fig. 46. DISPLAY Setup/PASSWORD screen.
65-0311—02
Use up/down arrows to change numbers and left/right arrows
to move the cursor to enter your new password.
Press ENTER using the two ENTER buttons at the same time.
The Select/Exit Screen (see Fig. 33) will appear. Choose
Select and you will be in the DISPLAY Setup menu. The
DISPLAY Setup/Select PASSWORD screen (see Fig. 41) will
appear. Press ENTER using the two ENTER buttons at the
same time.
The Select/Exit Screen (see Fig. 33) will appear. Choose Exit
and you will be out of the Setup menu again.
Display Setup—CEA EDIT
CEA EDIT allows customizing or editing of messages 44 to 64
with a text message of up to 12 characters in length. See Table
9 for available characters. This message will be connected to a
specific terminal when CEA ASSIGN is programmed.
To access the CEA EDIT menu:
Press the left three buttons of the KDM for one second, then
release.
DISPLAY Setup will appear.
NOTE: If you have a personal password, enter it now to enter
Setup.
The DISPLAY Setup/PASSWORD screen (see Fig. 46) will
appear. Press ENTER by pressing the two ENTER buttons at
the same time.
The Select/Exit Screen (see Fig. 33) will appear. Choose
Select.
The DISPLAY Setup/Select CLONE screen (see Fig. 38) will
appear. Use the down arrow to scroll through the menu
choices until EAEDIT appears.
Fig. 47. DISPLAY Setup/Select EAEDIT screen.
Press ENTER using the two ENTER buttons at the same time.
The Select/Exit Screen (see Fig. 33) will appear. Choose
Select.
Fig. 48. CEA Edit/Edit Msg screen.
Use the up/down and left/right arrows to select Msg (message)
number you wish to edit. Press ENTER using the two ENTER
buttons at the same time to select.
28