Table of Contents
Advertisement
Accessing the MQAM Menus
You can access MQAM menus and screens by pressing the FREQ, LEVEL, CW, or
OPTIONS keys on the front panel.
Pressing these keys repeatedly scrolls through their respective sequential menus.
The following sections in this chapter describe the functions associated with each
key:
FREQ - Adjust the Frequencies of a Selected Carrier (on page 50)
LEVEL
- Adjust the RF Output Level of a Selected RF Module (on page 51)
- Mute the RF Output of a Selected RF Module (on page 52)
CW - Change the Carrier Mode of a Selected RF Module (on page 53)
OPTIONS - Monitor Setup Options (on page 54)
RF SEL – Adjusting the Output Frequency (on page 50)
Note: See Front Panel Overview (on page 7) for detailed descriptions of these keys.
Navigating Within a Menu or Changing a Screen Value
The Up and Down arrow keys are used in conjunction with the other front panel
keys to increment or decrement the values of a selected parameter within a screen or
to scroll up and down through a set of selections.
Saving Changes to Configuration Settings
Pressing the Enter key saves changes to the configuration settings. You must also
press the Enter key to return to the default status screen. Changes to any settings are
saved into NVRAM. This memory is located on the digital board and is used to
restore settings in the event of a power reset of the device.
78-717866-01 Rev D
Use the Front Panel Keys to Change Configuration Settings
49
Advertisement
Table of Contents
Troubleshooting
