Connecting The 10/100Baset Ethernet Port - Cisco D9477-1 Installation And Operation Manual

Connecting the 10/100BaseT Ethernet Port

Follow these steps to connect the MQAM to the Ethernet network.
1 Connect the DNCS to the ATM switch using multi-mode fiber.
Connect the ATM switch to the router using single-mode fiber.
2
3 Connect the router to the 10/100BaseT Ethernet hub using CAT-5 Ethernet
10/100BaseT wiring with RJ-45 connectors.
4 Connect the 10BaseT port on the MQAM to the QAM 10BaseT Ethernet hub
using 8-conductor Unshielded/Shielded Twisted Pair (UTP/STP) Ethernet
10BaseT wiring with RJ-45 connectors.
Note: For the Model D9477-3 MQAM, use a screened or shielded cable to connect
the MQAM to the QAM 10BaseT Ethernet hub. Place one ferrite clamp (part
number 1000636) within 0.5 inch of the connector on the MQAM end of the cable.
78-717866-01 Rev D
Connect the 10/100BaseT Ethernet Port
27