Chapter 2 Installing The Mqam - Cisco D9477-1 Installation And Operation Manual

78-717866-01 Rev D
2 Chapter 2
Installing the MQAM
Introduction
This chapter describes how to install the MQAM into a rack and where to
connect the MQAM to the other components within the DBDS. The
connections used for the MQAM vary according to its use in your system.
Refer to Technical Specifications (on page 85) for additional technical
specifications to help you install the MQAM in your system.
In This Chapter
 Installation Process Summary ............................................................. 12

Unpack and Inspect the MQAM ......................................................... 14

Install the Modulator Into a Rack ....................................................... 15

Connect Power Sources ........................................................................ 16

Record the MAC Address .................................................................... 18

Connect the RF OUT Ports .................................................................. 20

Connect the DVB ASI Input Ports ...................................................... 22

Connect the CA SYNC Port ................................................................. 24

Connect the 10/100BaseT Ethernet Port ............................................ 26
11