9. Tap the Back arrow to return to the Settings screen.
Scan Barcodes
By default, the integrated imager is enabled for scanning. It supports
omni-directional (360°) barcode scanning, and an aiming beam is provided to help
assist with targeting barcodes.
Before you start scanning barcodes, go into Settings
Scanning > Internal Scanner and modify the scan profile to enable only the
barcode symbologies that you need. By reducing the active symbology list, you can
increase scan speed.
1. Point the imager window at the barcode. For
2. Press and hold any Scan button.
3. Center the aiming beam over the barcode. Make sure
4. Release the Scan button when the computer beeps
Note: Not all barcode symbologies are enabled by default. If a barcode does not scan, the
correct symbology may not be enabled.
About Scanning Configuration Barcodes
After completing the out-of-box set up process, Provisioning Mode is
automatically turned Off. Scanning a barcode to install applications, certificates,
configuration files, and licenses on the computer is restricted unless you enable
Provisioning Mode in the Settings app.
To learn more
CT47 Mobile Computer Series User Guide
The digital scan button appears on the screen when you open any of the apps
you selected during the button setup. Tap and hold the button to activate the
imager and scan a barcode.
optimum performance, avoid reflections by
scanning the barcode at a slight angle.
the entire barcode is inside of the illumination frame.
and the Good Read LED briefly turns On. The
barcode information is entered into the application
in use.
About Provisioning
Mode, see page 85.
> Honeywell Settings >
45