Add A Scan Setting Profile - Honeywell CT47 Series User Manual

Setting
Trigger Scan
Mode
Presentation
Mode
Same symbol
timeout
Notification Settings
Use the Notification Settings to configure how your computer responds when you
scan a barcode.
Notification Settings
Setting
Good Read Notification
Bad Read Notification
Vibrate On Notification

Add a Scan Setting Profile

To create a scan setting profile for a custom app on the computer:
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Settings
3. Tap
4. Take one of the following actions:
CT47 Mobile Computer Series User Guide
Description
Set read behavior on scan button press.
Options available:
•
•
•
•
Presentation Mode uses ambient light and scanner illumination to
detect barcodes. When in Presentation Mode, the LEDs remain
dim until a barcode is presented to the scanner, then the aimer
turns on and the LEDs turn up to read the code. If the light level in
the room is not high enough, Presentation Mode may not work
properly.
Set the minimum buffer time in seconds before the scanner reads
the same barcode. This can be adjusted to prevent inadvertent
scans of the same barcode if the code is left in the scan field longer
than the Decode Timeout limit. The default same symbol timeout is
1000 seconds.
> Honeywell Settings > Scanning > Internal Scanner.
in the upper right corner of the app screen.
• Tap the Profile name field, and then add a new name.
One Shot
Continuous
Read on release
Read on second trigger press
Description
Enables or disables a good read notification. The
notification consists of a green blink of the Good Read
LED, a short beep, and an optional short vibration.
Enables or disables notification of a failed scan. The
notification consists of a red blink of the Good Read LED,
an error beep, and an optional short vibration.
Enables or disables whether the computer vibrates when
there is a good or bad read.
Default
One
Shot
Disabled
Disabled
Default
Enabled
Disabled
Disabled
43