NETGEAR WG511T User Manual page 29

c. Click Close to exit the Smart Wizard, or Cancel to return to the previous settings.
3. Configure the PC network settings.
a. Configure each PC with either a static IP address or with the IPX protocol.
Note: For instructions on configuring static IP addresses, refer to the networking
tutorial on your NETGEAR CD.
b. Restart the PCs.
4. Verify wireless connectivity between your peer devices.
Verify connectivity by using the Ping program:
a. On the Windows taskbar click the Start button, and then click Run.
Figure 2-7
b. Assuming the target PC is configured with 192.168.0.1 as its IP address, type
192.168.0.1
c. This will cause a continuous ping to be sent to the device with the 192.168.0.1 static IP
address. The ping response should change to "reply."
Figure 2-8
At this point the connection is established.
Network Connections and Wireless Security
NETGEAR 108 Mbps Wireless PC Card WG511T User Manual
and then click OK.
v3.0, January 2007
ping -t
2-9