Makita UT001G Instruction Manual page 12

1. Open the standard equipped battery cover while
pressing the button on the battery cover.
2.
Loosen the screw securing the standard equipped
battery cover. Then remove the screw, sleeve and the
battery cover.
Fig.19
► 1 . Screw 2. Sleeve 3. Battery cover (standard
equipped)
NOTE: The sleeve may remain in the mounting holes.
In that case, pull it out using a screw or the like.
3. Align the mounting hole on the optional battery
cover with the mounting holes on the housing. Insert the
sleeve. Then tighten the screws to secure it in place.
Fig.20
► 1 . Screw 2. Sleeve 3. Battery cover (optional)
4. Close the battery cover securely.
Installing or removing the shaft
holder
country specific
For UT001G
Install one of the shaft holders optionally available to fit
3
your screw size of the shaft.
2
1
Fig.21
► 1 . M12 shaft holder 2. M14 shaft holder
While holding the spindle with a wrench, loosen the
shaft holder with another wrench.
3
3
2
1
Fig.22
► 1 . Shaft holder 2. Wrench 3. Spindle
To install the shaft holder, perform the removal proce-
dure in reverse.
For UT002G
1. Insert the hex wrench into the chuck, and then
loosen the chuck with the hex wrench while holding the
spindle with the wrench.
Fig.23
► 1 . Hex wrench 2. Chuck 3. Wrench 4. Spindle
12 ENGLISH
2
2
3
1
2
1
2
1
4