Makita UT001G Instruction Manual page 10

To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge.
Fig.14
► 1 . Red indicator 2. Button 3. Battery cartridge
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator as
shown in the figure, it is not locked completely.
After installing the battery cartridge, close the battery
cover securely.
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not,
it may accidentally fall out of the tool, causing injury to
you or someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
Switch action
WARNING:
Before installing the battery car-
tridge into the tool, always make sure that the
switch trigger actuates properly and returns to the
"OFF" position by fully pulling and releasing it.
WARNING:
NEVER defeat the lock-off button
by taping down or some other means. A switch with
a negated lock-off button may result in unintentional
operation and serious personal injury.
WARNING:
NEVER use the tool if it runs when you
simply pull the switch trigger without pressing the lock-off
button. A switch in need of repair may result in unintentional
operation and serious personal injury. Return tool to a Makita
service center for proper repairs BEFORE further usage.
WARNING:
Do not install the battery cartridge
with the lock button engaged.
2
3
1
1
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided. To start the tool,
depress the lock-off button and pull the switch trigger.
Tool speed is increased by increasing pressure on the
switch trigger. Release the switch trigger to stop.
For continuous operation, depress the lock button while
pulling the switch trigger, and then release the switch trigger.
To stop the tool, pull the switch trigger fully, then release it.
1
Fig.15
► 1 . Switch trigger 2. Lock-off button 3. Lock button
Operation of speed change knob
NOTICE:
Use the speed change knob only after
the tool comes to a complete stop. Changing the tool
speed mode before the tool stops may damage the tool.
NOTICE:
Always set the speed change knob carefully
into the correct position. If you operate the tool with the
speed change knob positioned halfway between the posi-
tion 1 and the position 2, the tool may be damaged.
NOTICE:
If the rotation speed significantly
decreases during operation in the high speed
mode, stop the tool and change the mode to the
low speed mode. Otherwise, the motor may get
overloaded and cause a malfunction or fire.
Two speed ranges can be preselected with the speed change knob.
Select the proper speed mode for the material to be mixed.
To change the speed mode, turn the speed change knob
so that the pointer points to the dot at position 1 for low
speed mode or the dot at position 2 for high speed mode.
Fig.16
► 1 . Pointer 2. Speed change knob 3. Dot
10 ENGLISH
2
3
3
2
1
3