ENGLISH (Original instructions) SPECIFICATIONS Model: UA004G Overall length 2,516 - 3,748 mm (without guide bar and battery) Rated voltage D.C. 36 V - 40 V max Net weight 7.8 kg 7.8 - 9.1 kg Standard guide bar length 300 mm...
Saw chain, guide bar, and sprocket combination Saw chain type 90PX Number of drive links Guide bar Guide bar length 300 mm Cutting length 296 mm Pitch 3/8″ Gauge 1.1 mm Type Sprocket nose bar Sprocket Number of teeth Pitch 3/8″...
Noise WARNING: Wear ear protection. WARNING: The noise emission during actual The typical A-weighted noise level determined accord- use of the power tool can differ from the declared ing to ISO22868(ISO11680-1): value(s) depending on the ways in which the Sound pressure level (L ) : 90 dB (A) tool is used especially what kind of workpiece is Sound power level (L...
Page 13
Before assembling or adjusting the tool, switch condition before continuing work. If there is off the tool and remove the battery cartridge. any damage or doubt, ask Makita authorized Before handling the saw chain or adjusting the service center for the inspection and repair.
Page 14
First, clear has become blunt and cutting performance is obstructs such as limbs and branches from poor, ask Makita authorized service center to the work area. Move all tools and goods from sharpen it or replace it with new one.
Do not nail, cut, crush, throw, drop the battery also void the Makita warranty for the Makita tool and cartridge, or hit against a hard object to the charger. battery cartridge. Such conduct may result in a fire, excessive heat, or explosion.
Let the machine and battery(ies) cool down. 50% to 75% If no improvement can be found by restoring protection 25% to 50% system, then contact your local Makita Service Center. 0% to 25% Charge the battery. The battery may have malfunctioned.
Main power switch ASSEMBLY WARNING: Always turn off the main power CAUTION: Always be sure that the tool is switch when not in use. switched off and the battery cartridge is removed before carrying out any work on the tool. To turn on the tool, press the main power switch.
NOTICE: Use the saw chain oil exclusively for cover. Makita chain saws or equivalent oil available in ► Fig.18: 1. Sprocket cover 2. Protrusion 3. Bolt the market. 4. Pin NOTICE:...
Page 19
Stand on a stable surface, and hold the tool away from hanging band recommended by Makita. the branches so that the angle of the tool becomes 60° or less against the horizontal ground.
To maintain product SAFETY and RELIABILITY, — Sharpen the shortest cutter first. Then the length repairs, any other maintenance or adjustment should of this shortest cutter becomes the standard for all be performed by Makita Authorized or Factory Service other cutters on the saw chain. Centers, always using Makita replacement parts. — Guide the file as shown in the figure.
Before fitting a new saw chain, check the condition of discharge hole as follows. the sprocket. If the sprocket is worn or damaged, ask Makita Authorized Service Centers for replacement. Remove the sprocket cover and saw chain from ► Fig.51: 1. Sprocket 2. Areas to be worn out the tool.
TROUBLESHOOTING Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the manual, do not attempt to dismantle the tool. Instead, ask Makita Authorized Service Centers, always using Makita replace- ment parts for repairs. Malfunction status Cause Action The tool does not start. Battery cartridge is not installed. Install a charged battery cartridge.