Power Connections
Figure 3-52 DC Wiring—Power Supply with Terminal Block in Cisco 3660 Routers
Wire management bracket
If your router has two power supplies installed, repeat Step
Step 6
Step 7
Turn on power to the DC circuit.
Connecting Routers to the Cisco Redundant Power System
If your router uses the Cisco Redundant Power System (RPS), refer to the
Installation Guide
location described in the
Cisco 3600 Series Routers Hardware Installation Guide
3-36
+
Negative
Positive
for instructions about the power connections. You can access this document at the
"Obtaining Documentation" section on page
DC terminal
block
Safety ground
1
through Step
5
Cisco RPS Hardware
xvii.
Chapter 3
Installing the Router
for the second power supply.
OL-2056-05