Cisco Router 3600 Hardware Installation Manual page 106

Configuring the Router
Respond to the following prompts. Select [2] to save the initial configuration.:
Step 12
The user prompt appears:
Step 13
After you complete the initial configuration tasks, your Cisco router is ready to configure for specific
functions. For configuration procedures, refer to the
Series, Cisco 3600 Series, and Cisco 3700 Series Routers
documentation. You can access these documents on Cisco.com and on the Documentation CD-ROM.
Cisco 3600 Series Routers Hardware Installation Guide
3-56
!
interface FastEthernet0/0
no shutdown
media-type 100BaseX
half-duplex
ip address 172.1.2.3 255.255.0.0
!
interface FastEthernet0/1
shutdown
no ip address
!
end
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
3600>
Chapter 3
Software Configuration Guide for Cisco 2600
or the Cisco IOS software configuration
Installing the Router
OL-2056-05