Powering Up The Router; Checklist For Power Up; Front Panel Indicators - Cisco Router 3600 Hardware Installation Manual

Chapter 3 Installing the Router

Powering Up the Router

The plug-socket combination must be accessible at all times because it serves as the main
Warning
disconnecting device. Statement 1019
To ensure adequate cooling, never operate the router unless the unit is completely closed.
Caution
This section covers the following topics:
•
•
•

Checklist for Power Up

You are ready to power up the Cisco router if the following steps are completed:
•
•
•
•
•

Front Panel Indicators

The following indicator LEDs provide power, activity, and status information:
•
•
•
For more detailed information about the LEDs, see
OL-2056-05
Checklist for Power Up, page 3-51
Front Panel Indicators, page 3-51
Power-Up Procedure, page 3-52
Chassis is securely mounted.
Power and interface cables are connected.
Your PC terminal emulation program is configured for 9600 baud, 8 data bits, 1 stop bit, and no
parity.
You have selected passwords for access control.
You have determined the IP addresses for the Ethernet and serial interfaces.
Power (green)—Lit when power is on
Sys/RPS (green):
– Rapid blinking (200 ms)—System is booting
– Slow blinking (1 s)—Redundant power supply (RPS) failure
– Continuous on—System OK
Activity (green)—Blinks during system activity, such as interrupts and packet transfers
Appendix A, "Troubleshooting."
Cisco 3600 Series Routers Hardware Installation Guide
Powering Up the Router
3-51