Cisco Router 3600 Hardware Installation Manual page 122

Error Messages
Table A-10 Cisco 3660 System Error and Status Messages (continued)
LED Type LED Color
PS1, PS2, Amber
LED on
power
supply rear
panel
PS1, PS2, Amber
LED on
power
supply rear
panel
Cisco 3600 Series Routers Hardware Installation Guide
A-14
Message
Error:
%PS-3-DCOUTPUTVOLTFAIL: System detected Power System # DC FAIL condition.
Explanation:
The cable connected to the specified DC power supply (1 or 2) is loose or the DC power supply
has failed.
Recovery:
Check the power supply LEDs to identify the faulty unit.
1.
Power off the faulty power supply and circuit breaker.
2.
Check that cables are seated properly and terminal blocks are wired correctly.
3.
Power on the circuit breaker and the power supply.
4.
5. If the error condition persists, replace the DC power supply. Refer to the
Universal DC Power Supplies in Cisco 3660 Routers
in Cisco 3600 Series Routers
When the error condition is resolved, the following informational message appears:
%PS-3-DCOUTPUTVOLTOK: Power System DC condition is now normal.
Error:
%PS-3-INPUTVOLTFAIL: System detected Power System # AC FAIL condition.
Explanation:
The cable connected to the specified AC power supply (1 or 2) is loose or the AC power supply
has failed.
Recovery:
Check the power supply LEDs to identify the faulty unit.
1.
2. Power off the faulty power supply.
3. Check that cables are seated properly and terminal blocks are wired correctly.
4. Power on the power supply.
If the error condition persists, replace the AC power supply. Refer to the
5.
Supplies in Cisco 3600 Series Routers
When the error condition is resolved, the following informational message appears:
%PS-3-INPUTVOLTOK: Power System AC condition is now normal.
or to the
hardware configuration note.
hardware configuration note.
Appendix A Troubleshooting
Installing
Installing Power Supplies
Installing Power
OL-2056-05