Cisco Router 3600 Hardware Installation Manual page 82

Power Connections
The safety cover is an integral part of the product. Do not operate the unit without the safety cover
Warning
installed. Operating the unit without the cover in place will invalidate the safety approvals and pose
a risk of fire and electrical hazards. Statement 117
Secure the wires using cable ties as shown in
Step 7
and to the right of the terminal block.
Turn on power to the DC circuit.
Step 8
Figure 3-47 Wire Routing and Attachment for Cisco 3631 Routers
Plastic covers
Wiring the DC-Input Power Supply in Cisco 3660 Routers
If your router has a DC-input power supply, follow the directions in this section for proper wiring.
DC Wiring Requirements
A Cisco 3660 router with a DC-input power supply requires copper wire for the power connections.
Table 3-3
Cisco 3600 Series Routers Hardware Installation Guide
3-32
+
A
+
B
summarizes the wiring requirements.
Figure 3-47. The chassis has a cable-tie attachment below
Cable tie
From DC
power
source
Chapter 3 Installing the Router
OL-2056-05