Lifting The Chassis - Cisco 10008 Quick Start Manual

Lifting the Chassis

Use the following procedure to rack-mount the Cisco 10008 chassis:
Figure 1 Lifting the Chassis
MISW IRE
MISW IRE
Warning At least three people are required to mount the chassis in the equipment rack: two people are needed to hold the
chassis in place while a third person tightens the mounting screws. Statement 234
Each person should stand on either side of the chassis, and place one hand under the air intake at the bottom front of
Step 1
the chassis.
With the other hand, grasp the top rear of the chassis under the air exhaust and carefully lift the chassis.
Step 2
Lift the chassis into position between the rack posts.
Step 3
To install the Cisco 10008 in an equipment rack, go to:
Rack-Mounting the Router in a 19-Inch 4-Post Rack, page 10
•
Rack-Mounting the Router in a 19-Inch 2-Post Rack, page 11
•
Rack-Mounting the Router in a 23-Inch 2-Post Rack, page 13
•
FANS
FAN MULTI-
OK FAILUR
E FAN
FAILUR E
CAUT ION
When hot
remov al swapp ing this fan
be done and replac ement tray,
system in under two minute must
shutdo wn will s or
occur.
1
2
3
4
0A
PRO CES
CISC O SOR ONL 0B
CISC O
10000 Y 5
10000 CISC O
10000 CISC O 6
7
10000 CISC O 8
10000 CISC O
10000 CISC O
10000 CISC O
10000 CISC O
10000 CISC O
10000
POW ER
FAUL T
POW ER
FAUL T
PRO CES
SOR ONL
Y
9