Cisco 10008 Quick Start Manual page 33

The RJ-45 port on the PRE is configurable for 100-Mbps full-duplex or half-duplex operation (half-duplex is the default) and
supports IEEE 802.3, Ethernet, and IEEE 802.3u interfaces compliant with 100BASE-T specifications.
Follow these steps to connect the PRE to a 100BASE-T Ethernet LAN:
Figure 26 Connecting the 100BASE-T Cable to the Ethernet Port
Connect one end of the Ethernet cable to the RJ-45 port on the primary PRE, labeled ETHERNET.
Step 1
Run the cable up and through the cable management bracket and connect the other end of the Ethernet cable to any
Step 2
unoccupied port on the Ethernet hub.
Step 3 Check the LINK LED on the PRE faceplate (next to the ETHERNET port). This LED lights (green) if the PRE is
correctly connected to the 100BASE-T Ethernet LAN.
C IS C O
1 0 0 0 0
33